airHeaterByBLE

It works well for what’s it’s intended to do outside of the fact that the regulation of fan speed isn’t great. What I mean by that is that let’s say you set it to thermostat mode and set the temp to 60 F. If it’s 40 F when the unit turns on it will automatically set the fan/blower speed to raise the temp but the closer it gets to your set temp the lower the blower speed goes so it never reaches the set temp. Right now I have it set at 60 F and it’s currently 40 F. The unit has been on for hours and the temp did climb but the blower speed is at “3” and that’s not enough to break past the temp difference barrier. So in conclusion like I said it works pretty well but it slows down the blower too much so it can’t reach the set temp. They have to update the apps logic for this.

The app works pretty well but ever since it updated I have been having issues with it shutting off my heater when I close the app. I don’t know if it’s because I’m on iPhone and the power button is at the bottom and when I close the app it hits the button? I’m not sure why it does this but it is annoying.

As the title states the app works for the most part. My biggest issue with this app is turning off and on the heater. The power button must be pressed for an exact amount of time to cycle on or off. However, if the power is held too long or too short nothing happens, OR (my personal peeve) is that if you do manage to turn it off, IT WILL START UP AGAIN WITH NO USER INPUT!!! Too many times I have gone to work a 10 hour shift and come home to my heater RUNNING after I turned it off. Other issues I have are that it doesn’t report the correct elevation. I’ve seen it range from 170m to 250+m. I’ve noticed that the “elevation” is actually air pressure. Another bigger issue is that it doesn’t report the correct air temperature either. The temperature reported by the heater and actual air temperature is off by at least 10C!