iSLa

Installation instructions found at the manufacturers site (quite frustrating also). After plugging the wifi module in, the setup is like Tomorrow War (the movie); start at the beginning, go as far as the process crashes - sometimes because of nothing, sometimes because you tapped or didn’t tap something - and the process freezes permanently. Reset the module with the magnet and start over, wishing better luck next go. Repeat endlessly. If you happen to manage to connect the module (the next day most likely, couldn’t do it in one go), you have a few functions available. But whatever you try to do, the response is always the same: ”the machine couldn’t confirm your action” or some yada yada like that. It’s a small wonder something this bad can even be implemented and be published.

Everything from installation to using it is so bad that its almost hilarious. Setting it up took hours because the app crashed every time in the middle of firmware update which was necessary. The reset magnet was an unique solution, but with absolutely no instructions available I had to figure out how it works by rubbing it against every side of the wifi-module. Finally after numerous attempts I finally got it to connect, just to find out that the app doesnt work in any way. When you start the app it takes more than three minutes to even open, and none of the functions work. If you try to put on for example the boost or fireplace function, it loads for quite a while, and then just casually announces that whatever you wanted to do, couldnt be done. What a waste of time and money, stay away from this.

Ei onnistu yhteyden ottaminen Enerventin Sallaan vaikka mitä tekisi. 1/5